BENSHAW ENHANCED KEYPAD Manual de usuario descargar pdf (Pagina 53)

3.10.3 Installing Display

The remote display is installed as follows:

• Install the gasket onto the display.

• Insert the display through the door cutout.

• Insert the mounting clips into the holes in each side of the display.

• Tighten the mounting clips until they hold the display securely in place. Torque requirements for the display screen is 0.7 NM (6.195

in lbs).

• Plug the cable into the display connector on the MX

card. See Figure 12 – Control Card Layout on page 39 for the connector

location.

• Route the cable through the enclosure to the display. Observe the wiring considerations as listed in section 3.4.3 on page 31.

• Plug the other end of the cable into the LCD display.

z NOTE: At temperatures less than -20°C, the LCD contrast may be impaired.

3 - INSTALLATION

MX² DISPLAY

GASKET

ENCLOSURE DOOR

MX² DISPLAY CABLE

CLIP

Figure 21: Mounting Remote Keypads

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 221 222

Sin comentarios

BENSHAW ENHANCED KEYPAD Manual de usuario Pagina 53