BENSHAW ENHANCED KEYPAD Manual de usuario descargar pdf (Pagina 144)

136

7 - PARAMETER DESCRIPTION

These ve characteristics are congured by two parameters for each state. These parameters are named

“Seq Cntl X” and Seq Count X,” where X represents the state number of the sequencer (1-9). The “Seq

Cntl X” parameter is a binary parameter that sets each of the ve characteristics listed above. “Seq Count

X” uses bits 4,5,6 and congures the threshold that the sequencer will use in determining when to advance

to the next stage by the method programmed in the control parameter. The descriptions for “Seq Count X”

is under the title “Description of Seq Count Function”. The bit patterns of the “Seq Cntl X” parameters are

shown below.

S4 Sequencer Speed Selection (Bits 0, 1, 2)

The table below gives more information on the speed selection options available in the S4 sequencer by

programming bits 0, 1 and 2 of each state’s control parameter. The options include any Preset Speed, Max

Frequency, or allowing the reference to be determined in the normal S4 control path.

S4 Seq Cntl Parameter: Bit Denition

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 181 182

Sin comentarios

BENSHAW ENHANCED KEYPAD Manual de usuario Pagina 144